|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I'm so glad I was able to find a site to download my missing manuals. Very reasonable prices and they kept me informed about the process and I had my manual within less than a day. The only thing I wish was an option is a 100% English version with no spanish or anything. But overall great site.
;
The manual is complete with excellent quality! One suggestion, show number of pages and weather it is multi-lingual. The AD 600 Manuel is about 76 pages and over half is non English. This results in a larger print job than usually needed. Having this information, one could select the desired pages for printing.
 ;
I've been looking for a copy of the original user/owner manual. Just what the doctor ordered, thank you.
;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
HP J06-59992A Time Interval Calibrator
Theory of Operation
B1
1-1
'
OUTPUT A In-phase OUTPUT B OUTPUT A In-phase/Swap P2 OUTPUT B OUTPUT A Out-of-phase OUTPUT B OUTPUT A Out-of-phase/Swap OUTPUT B
Figure 4-1. HP-1B Command Swnmary.
4-7. INPUT SIGNAL CONVERSION
INPUT
SPLITTER B2 Zero SPLITTER B3 INPUT
B4
180
P2
171
SPLITTER N2
eg
The zero degree power-splitter divides the input signal into two nearly inphase output signals, PI and P 2 Command "Bl" routes the input signal from P l to Output A and P2 to Output B;'732"routes the input from P1 to Output B and P2 to Output A Similarly, the 180-degree power-splitter divides the input into two nearly out-of -phase signals, N 1 and N2. Command "B3" routes the input signal from N 1 to Output A and N2 to Output 8; '%4" routes the input from N 1 to Output B and N2 to Output A Refer to Figure 4- 1 for a diagram illustrating the effect of the HP-IB commands. The commands "Bl -B4",(or switches 1-4 if manually operated), result in four binary states defined by the two bits arriving on A D 4 pin 4 and pin 6. The bit from pin 4, via buffers in A2U 1 energizes the appropriate relays A2K 1 and A2K2, routing the incoming signal from A2J1 to the desired powersplitter. The outputs of the selected splitter are fed to A2K3 where they are connected to Outputs A and B directly, or reversed through a cross-over K3 relay arrangement. Note that the input signal to the splitters and the output signals from the splitters are ac-coupled via blocking capacitors A2C 1, C8, and C9. Table 4- 1 summarizes the J06-59992A operation.
Page 4-2
www.hparchive.com
|
|
|
> |
|
